Do you know the working principle of the booster pump? Today, the editor of Low price oxygen booster pump will take you to find out.
First fill the booster pump with liquid, and then start the centrifugal pump. The impeller rotates quickly. The blades of the impeller drive the liquid to rotate. When the liquid rotates, it flows to the outer edge of the impeller by inertia, while the impeller sucks in the liquid from the suction chamber. In the impeller, the liquid in the impeller flows around the blades. During the circumfluence, the liquid acts on the blades. In turn, the blades act on the liquid with a force equal to the lift and in the opposite direction. This force does work on the liquid to obtain the liquid. The energy flows out of the impeller, and the kinetic energy and pressure energy of the liquid increase at this time.

Introduction of Low price oxygen booster pump: The working principle of gas-liquid booster pump is similar to that of pressure booster. It applies a very low pressure to the large-diameter air-driven piston. When this pressure acts on a small-area piston, a high pressure is generated. Through a two-position five-way air-controlled reversing valve, the booster pump can realize continuous operation. The high-pressure plunger controlled by the one-way valve continuously discharges the liquid, and the outlet pressure of the booster pump is related to the air driving pressure. When the pressure between the driving part and the output liquid part reaches a balance, the booster pump will stop running and no longer consume air. When the output pressure drops or the air drive pressure increases, the booster pump will automatically start and run until it reaches the pressure balance again and then stops automatically. A single gas control non-balanced gas distribution valve is used to realize the automatic reciprocating movement of the pump, and the gas drive part of the pump body is made of aluminum alloy. The wetted parts can be made of carbon steel or stainless steel according to different media. Generally, a pump has two ports for air intake and exhaust. The one that can produce pressure lower than normal pressure (ie atmospheric pressure) at the inlet is called "negative pressure"; the one that can produce pressure higher than normal pressure at the exhaust port is called "positive" For example, the vacuum pump is often said to be a negative pressure pump, and the booster pump is a positive pressure pump. Positive pressure pumps are very different from negative pressure pumps. For example, the gas flow direction, the negative pressure pump is the external air is sucked into the suction nozzle; the positive pressure is ejected from the exhaust nozzle; such as the level of the air pressure.
The above is a brief introduction to the relevant knowledge of Low price oxygen booster pump.